Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
mode to use?
07-05-2012, 10:14 AM,
Post: #1
mode to use?
I am tring to send a file from a server to this ether-serial port then onto a cnc machine and am wondering which mode I should use? I have tried driver mode and cannot communicate after setting up baud rate etc......
07-11-2012, 09:57 AM,
Post: #2
RE: mode to use?
Driver mode is definitely the most straight forward mode when using on a Windows based machine.

Are you using any specific software to communicate with the CNC machine, or are you simply sending a text file through a terminal program?

In addition, have you verified that you're in fact able to communicate through the ESL before hooking it up to the CNC Machine?

Forum Jump:

Users browsing this thread: 1 Guest(s)