Trying to set the Parallel Port speed - Printable Version +- LAVA: Forums (https://forum.lavalink.com) +-- Forum: LAVA IP System: LIPS (https://forum.lavalink.com/forumdisplay.php?fid=58) +--- Forum: Troubleshooting (https://forum.lavalink.com/forumdisplay.php?fid=62) +--- Thread: Trying to set the Parallel Port speed (/showthread.php?tid=21400) |
Trying to set the Parallel Port speed - jheinrichs - 05-25-2016 I have a very old BOCA printer that I want to get working on my Windows 7 64bit machine. I have installed and verified that the printer is installed and working through Windows Device manager. On the machine that I previously used I had to set the parallel port to PS/2 mode. ECP and EPP didn't work with the printer. My Lava Card is: PN - MOKO L72.2A It also has: TS-04 94V-0 4302 on the card. I used this driver: http://lavalink.com/support-drivers/pci-bus-io-cards/parallel-pci-pci-1-port-epp/ The description says EPP but I am hoping that I can use a different mode. I did go to this link: http://lavalink.com/support-drivers/lava-software-utilities/ but non of the utilities seem to work with a fully patched Windows 7 64bit machine. |