Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to determine IRQ assignment in IP Extender
11-29-2016, 06:28 PM,
Post: #1
How to determine IRQ assignment in IP Extender
I think that I have an IRQ conflict with virtual COM4. I would like to reassign IRQ to test theory.

Minidump reports Interrupt storm as source of fatal.
Reply
12-05-2016, 11:42 AM,
Post: #2
RE: How to determine IRQ assignment in IP Extender
Unfortunately with the driver being a virtual port all of the interrupt configuration and selection is performed under the hood by Microsoft so there is really no way select a different interrupt.

Was this ESL working fine before and did this issue recently pop up? That being said I would suggest performing a full uninstall and reinstall of the ESL driver to see if that resolves the issue.

- Lava Support
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)