Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Default password for LAVA Ether-Serial Link
11-14-2011, 08:00 PM, (This post was last modified: 11-21-2011, 04:26 PM by admin.)
Post: #1
Default password for LAVA Ether-Serial Link
Issue:
The Ether-Serial Link (ESL) is password protected after a factory default reload, or when received from the factory. In order to configure the device via the Lava Manager or embedded webpage the user must provide a password.

Resolution:
For full administration access the configuration password is “admin”.

For port level access the configuration password is “portN”, where N is the logical port number. (i.e. Port 1 password would be “port1”, etc).

Applies to:
- All ESL Devices
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)